GN Thermoforming Equipment Co.

The GN800 is a High Speed Form/Cut/Stack Thermoformer, the first GN model that offers movable top and bottom platens. In partnership with an experienced Italian machine manufacturer, GN is re-introducing to the market a Form/Cut/Stack Thermoformer that was manufactured and distributed worldwide for many years. With the input of customers and toolmakers, the enhanced GN800 will continue to service the production requirements of companies around the world.

Main Features:
Forming 150mm (5.9") above and below sheet line
High efficiency heaters
Increased tonnage in both forming and cutting stations
In-mould-cut capability
Optional stacking systems
Optional punching station
Multi-purpose thermoformer for food, medical, industrial and other special applications

Optional Equipment:
Material pre-heating system
Motorized material unwind unit (required when no pre-heater is used)

GN Tooling
Cost effective tooling is designed, manufactured and production tested at our facility

The GN760 is a Plug-Assist Thermoformer incorporating GN Thermoforming Technology achieved through continuous research and development.

Main Features:
In-mould cutting
Unique plug drive with twin servo motors
Radiant heat system with 60 zones
Robotic handling system
Advance diagnostics
Powerful GN toggle system
Energy conservation with power regeneration circuitry

Optional Equipment:
Material pre-heating system
Motorized material unwind unit (required when no pre-heater is used)

GN Tooling
Cost effective tooling is designed, manufactured and production tested at our facility

The GN1914DM with patented technology is a plug-assisted, Dual Mould Thermoforming Machine equipped with multi-zone upper and lower ovens. It will thermoform parts to a depth of 152mm (6") in two negative moulds each having a maximum forming area of 482mm x 355mm (19" x 14"). The GN1914DM utilizes an in-mould trim that guarantees the production of 100% identical parts while keeping tooling costs at a fraction of other in-mould cutting systems. Parts are handled by a robotic part handling system ensuring the steady, dependable delivery of stacked product. This extremely smooth operating machine truly is a high-output, high-volume Thermoformer.

Features and Benefits
Robotic product handling system
Built-in diagnostic system
Multi-zone upper and lower ovens incorporating an infrared heating system
Positive and negative forming
Quick tool changes

Optional Equipment
Material preheating station
Servo plug
Magnetic quick tool change system
Motorized material roll holder
Scrap handling system
Additional zoning of upper and lower ovens

GN Tooling
Cost effective tooling is designed, manufactured and production tested at our facility

Features and Benefits
The GN3021DX Thermoformer was developed to meet the demand for thermoformed APET products. It was designed to provide greater APET cutting capacity than the standard
Contact-Heat Cut-In-Place GN3021C Thermoformer
In-mould cutting ensuring consistent and accurate trim
Servo-driven platen for smooth and energy efficient movement
Four point toggle systems with oversized roller bearings
High speed forming system
Multi-zone contact heating system
Electric pre-heater
Microprocessor-based control systems (PLC)
Photo scanning available for preprinted sheet
Static eliminator
Stacking equipment available

GN Tooling
Cost effective tooling is designed, manufactured and production tested at our facility