Product category: Compression and transfer moulding presses for composites
Press line for laminating
The line is based on a multi-open through-feed hydraulic press and is designed for to laminating the panels with phenolic film or decorative foils.
Panel transport in-out of the press is carried out via conveyer belt, in-feed and out-feed device and transport bands on the heating plates in the press. The bands on the heating plates are made of temperature-resistant material and are fixed on special clamping bars. The bars are designed to assure quick exchange of bands and permanent tensioning force.
Description of the loading and unloading of the press: via conveyer belt in front of the in-feed device are loaded the multi open device. The in-feed device levels with the press opens and all panels are transported into the press at the same time. The closing of the press, pressing and adhesive bonding set in. When the cycle of hot pressing is finished, the press opens and levels with the out-feed device. All the panels are transported in out-feed device at the same time. From the out-feed device, the panels are individually transported onto the conveyer belt.
• Rub (abrasion) free panel transport – damage free product surface
• Various types of end surface of panels: smooth or non-slip or structural surface
• Ground level installation – no pit required
• Besides lamination even making a layered composite plates
Floor, Wall, Ceiling,