Segmentradtrockner DRYMAX Aton2 F30, F70 und F120
This innovative dryer technology segments desiccant beads in to multiple chambers of the rotating wheel. This provides maximum energy efficiency and allows for easy replacement of the desiccant beads as an alternative to a costly wheel replacement.
Dew Point as low as -65°C (-85°F)
3-Save Process – Intelligent use of Energy
Multi-level processes use the existing heating energy of the dryer to significantly reduce energy consumption. The combination of counter airflow regeneration, radiant heat recovery, and efficient heater design make up the 3-Save Process.
EcoMode – Indexing regeneration during lower water load
During high water loads, continuous wheel mode provides the best dry air conditions. The DRYMAX Aton adjusts automatically the regeneration temperatur when the material throughput or water load in the plastic resin is reduced. In EcoMode the regeneration works by indexing portions of the wheel and is saving energy.
The actual energy consumption can be monitored on the display.
The innovative control bezel conveniently displays the operating mode and dryer status through the use of color coded illumination.
Material Protection Function
Prevents over-drying and thermal degradation of plastic resin during periods of reduced throughput by automatically lowering the drying temperature.
Dew Point Management
The user settable dew point automatically adjusts the regeneration temperature to achieve maximum energy savings.